RPC Series Manual REMOTE POWER CONTROL QUICK START For Horizontal and Vertical Units BayTech Manual Publication Revision May 2008
10 Login Setup Menu Figure 9 Access Control Enable or disable usernames and passwords for both network and serial port access. Telnet Login Pr
11 Figure 11 CABLING RJ-45 Cable IMPORTANT: The BayTech unit has an RJ45 port, which uses an 8-pin rollover cable to connect to the local EIA232 d
12 RPC RJ-45 pin Signals Pin EIA 232 Signal Signal Direction Description 1 DTR Out +10V when activated by DCD. Toggles on logout for modem disconn
13 Figures 1 and 2 provide visual representation of an RJ-45 receptacle and plug.
2 Copyright 2007 by Bay Technical Associates, Inc. BayTech, is a registered trademarks of Bay Technical Associates, Inc. Windows 2000®, Windows X
3 For those Administrators who have requested the bare minimum for this type of equipment, follow these steps exactly. If this is a new unit shipped
4 5. NOTE: The ‘root’ user can not be deleted. 6. Select ‘A’ to add user. Type the name and password at the prompts. 7. Press ‘Enter’ until get to
5 QUICK START: Combined RPC Series by Bay Technical Associates • Connect the 9FRJ45PC-4 adapter to the user’s computer • Connect the RPC EIA-232
6 Figure 1 Help Menu: Type Help followed by a <CR> to view the line commands for the RPC’s. Figure 2 Password setting: Once you have logg
7 Figure 3 Power Controller Configuration Menu: To select the configuration menu, type ‘config’ at the prompt. NOTE: If the unit display with the
8 Add a User: Select A), “Add user,” from the User Management Menu. Enter the name of the user to be added, followed by <cr>. NOTE: User name i
9 NOTE: For initial network access, the IP address, subnet mask, and gateway must be configured from the serial port. Default setting is 0.0.0.0. Fi
Comments to this Manuals