March 1996 893-863-A Bay Networks, Inc. Corporate Headquarters4401 Great America ParkwaySanta Clara, CA 950548 Federal StreetBillerica, MA 01821 Us
8 893-863-A Fiber Optic Cable Length Limitations The 10BASE-F standard permits you to use fiber optic cables up to 2000 meters long. However, the fib
893-863-A 9 Table 4 lists the most common cable and connector combina-tions, assuming the maximum permitted attenuation with ST connectors. The tab
10 893-863-A Installing a Media Adapter in a BayStack Hub The BayStack 10BASE-FL RDN Media Adapter is installed in a slot on the front of the BaySt
893-863-A 11 6. Verify the installation for the media adapter. Observe for the installed media adapter that the respective Media Adapter LED on the
12 893-863-A Bay Networks, Inc. One-year Limited Hardware Warranty Bay Networks warrants this hardware product will be free from defects in materia
893-863-A 13 Electromagnetic Emissions Meets requirements of:FCC Part 15, Class A Digital DevicesVCCI Class 1 ITEEN 55 022 (CISPR 22, Class B)Gener
© 1996 by Bay Networks, Inc. All rights reserved. Trademarks Bay Networks, BayStack, and Bay Networks Press are trademarks of Bay Networks, Inc. O
893-863-A 1 Introduction This guide describes the Bay Networks 10BASE-FL RDN Media Adapter for the BayStack 10BASE-T Hubs and provides instructions
2 893-863-A BayStack 10BASE-FL RDN Media Adapter The BayStack 10BASE-FL RDN Media Adapter is a modular 10BASE-FL port.The port is compatible with t
893-863-A 3 LEDs The BayStack 10BASE-FL RDN Media Adapter provides LEDs to indicate remote signaling and redundant link status. These LEDs are used
4 893-863-A Table 2 describes the LED combinations of the hub “Media Adapter” LED and the redundant fiber media adapter LEDs. Remote Signaling The B
893-863-A 5 Redundant Enable Jumper Jumper JP1 is used to set the port to operate in the redundant port mode. The 10BASE-FL RDN Media Adapter is sh
6 893-863-A Redundant Links The BayStack 10BASE-FL RDN Media Adapter supports redundant links between Bay Networks BayStack Ethernet hubs, System 5
893-863-A 7 For a pair of ports to operate in redundant mode:• Enable the JP1 jumper for redundant port mode on both of the media adapters in the r
Comments to this Manuals